DVI 3500HD Extend DVI, USB, RS-232 and Analog Audio up to 6,600 feet (2 km) The DVI 3500HD allows you to operate a single DVI-compliant computer at two physical locations. DVI, USB, analog audio, and RS-232 are extended from the local computer to the remote workstation. USB peripherals can be operated by the computer at either location exclusively. How It Works The DVI 3500HD system consists of a Sender and a Receiver unit. The Sender connects to the computer's DVI-compliant video card output, analog audio jack, RS-232 port, and USB port. The DVI 3500HD Receiver connects to the remote display and peripherals. Four strands of LC fiber optic cable connect the Sender and Receiver together. The DVI 3500HD has two modes of USB operation. When in local mode, the computer sees USB devices connected to the Sender. When in remote mode, the computer sees USB devices connected to the Receiver. Modes are switched using a switch on the front panel of the Sender. Note: Extension distance will depend on the type of fiber media used: Single Mode: WUXGA resolution @ 2000m (6,600ft) Multi-Mode : WUXGA resolution @ 500m (1,650ft)
		HDMI 1.3 to 3G-SDI Converter Convert HDMI 1.3 into SD/HD/3G-SDI at 1080p/60 Hz with L/R analog audio The Gefen HDMI1.3-2-3GSDI Converter takes an HDMI input signal and converts it to SDI/HD-SDI/3G-SDI output format (either SDI standard definition, HD-SDI high-definition, or 3G-SDI high-definition with ultra high bandwidth). Converted HDMI signals are mirrored onto two identical SDI BNC outputs. A single pair of RCA-type L/R analog audio output jacks enables monitoring of embedded HDMI audio via an external analog amplifier or receiver. LED indicators on the front and bottom of the unit provide HDMI and SDI signal status and troubleshooting assistance in the event of errors. How It Works An HDMI source is connected to the HDMI input on the HDMI 1.3 to 3GSDI Converter. An SDI device is connected to the SDI outputs on the Converter. The included power supply is connected to the HDMI 1.3 to 3GSDI Converter. When the HDMI source and the HDMI 1.3 to 3GSDI Converter are connected and powered on, audio/video signals are converted to the proper format on connected A/V output devices (displays, audio receivers). DIP switches on the underside of the unit allow presetting critical functions inside the Converter such as 3G Mapping Level, Test Pattern and RGB Range. Three (3) LED indicators on the front panel indicate the presence of data rates up to 3G-SDI, the presence of locked-on HDMI, and power to the unit.